パーツ

パーツは必要ありません。

  1. Press down on the grooved area firmly in the direction of arrow #1.
    • Press down on the grooved area firmly in the direction of arrow #1.

    • While maintaining the downwards pressure, push the back cover in the direction of arrow #2 until the back cover slides off.

    • Photos taken from: http://theinformr.com/uploads/manuals/si...

    コメントを追加する

  2. Turn off the phone before removing the battery to avoid damage.
    • Turn off the phone before removing the battery to avoid damage.

    • Press the latch on the battery in the direction of arrow #3.

    • Lift battery at the cutout on the side of the phone, then tilt upwards and remove.

    • It may be necessary to use the tip of a fingernail or a plastic lifting tool to remove the battery.

    • Photos taken from: http://theinformr.com/uploads/manuals/si...

    コメントを追加する

    • Firmly grasp the white casing of the phone with one hand and the blue cover with the other hand as seen in the first picture.

    • Pull up on the two plastic clips at the top of the phone.

    • While the clips are pulled up, pull the blue cover away from the white casing to remove it.

    コメントを追加する

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Along the side of the metal frame of the phone, locate the six screws.

    • Using a T5 screwdriver bit, unscrew the six 1/4 inch screws and store them in a safe place.

    • The screws are very small and can strip easily, so proper care is required when removing and storing the screws.

    コメントを追加する

    • To remove the back plastic cover, grasp the device with both hands as seen in the first picture.

    • Gently remove the motherboard from the back plastic cover.

    • The motherboard is fragile, so proper care is necessary when handling and storing in order to prevent damage.

    コメントを追加する

    • Turn over the keypad interface and using the blue plastic opening tool, gently pry the bottom of the metal frame.

    • Once loosened, the metal frame should be able to be lifted from the motherboard.

    コメントを追加する

    • Insert the fine-tipped spudger in between the motherboard and the keypad interface.

    • Gently work the spudger across the length of the motherboard.

    • An adhesive exists between the motherboard and the keypad interface.

    • Once loosened, the motherboard should easily separate from the keypad interface.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Joseph Casey

メンバー登録日: 2014年03月26日

401 ポイント

4のガイドは作成済み

チーム

Clemson, Team 6-6, Benson Spring 2014 Clemson, Team 6-6, Benson Spring 2014人のメンバー

CLEM-BENSON-S14S6G6

4 メンバー

18のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 123