Use a plastic opening tool to pry the silver portion front of the top away from the colored portion.
  • Use a plastic opening tool to pry the silver portion front of the top away from the colored portion.

コメントを追加する

There should be two screws holding the metal casing that holds the screen.  Using your Philips 0 Screwdriver, unscrew them and pull the casing outwards.
  • There should be two screws holding the metal casing that holds the screen. Using your Philips 0 Screwdriver, unscrew them and pull the casing outwards.

  • NOTE: Keep track of where you put the screws after you remove them. Keep screws of the same size together and away from screws of different sizes.

コメントを追加する

Now that you've pulled out the screen casing, look for four screws, there will be two on the right and left side of the casing.
  • Now that you've pulled out the screen casing, look for four screws, there will be two on the right and left side of the casing.

  • Using your off hand's thumb, hold the screen in place. Using the Philips 0 Screwdriver, unscrew them.

  • Carefully remove your hand, and gently let the screen down.

コメントを追加する

Disconnect the cord connecting the screen to the rest of the laptop; the cord will be affixed to the screen using tape, so it can be safely removed.  The actual cord connection is at the circuit board.
  • Disconnect the cord connecting the screen to the rest of the laptop; the cord will be affixed to the screen using tape, so it can be safely removed. The actual cord connection is at the circuit board.

コメントを追加する

Pull down the laptop's back; the screen should be left upright, held in place by two metal strips going along its sides.
  • Pull down the laptop's back; the screen should be left upright, held in place by two metal strips going along its sides.

  • On either side of these strips there will be two screws. Unscrew them on both sides. While unscrewing the screws on the second side, make sure to hold the screen so that it doesn't fall when the screws are removed.

コメントを追加する

Pull the screen out.  Congratulations!  You have removed the screen.
  • Pull the screen out. Congratulations! You have removed the screen.

コメントを追加する

Remove the 2 small screws above the screen at the center of the lid.
  • Remove the 2 small screws above the screen at the center of the lid.

コメントを追加する

Insert the webcam module so that the 2 screw holders match up with the 2 holes in the module
  • Insert the webcam module so that the 2 screw holders match up with the 2 holes in the module

コメントを追加する

Replace and tighten the 2 screws so that the module is held in place.
  • Replace and tighten the 2 screws so that the module is held in place.

コメントを追加する

Carefully connect the white cable running along the back of the screen to the appropriate docking station in the webcam module.
  • Carefully connect the white cable running along the back of the screen to the appropriate docking station in the webcam module.

コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

Arnesh Mudaliar

メンバー登録日: 2012年04月03日

8 ポイント

1ガイドが承認済み

チーム

Cal Poly, Team 14-10, Forte Spring 2012 Cal Poly, Team 14-10, Forte Spring 2012人のメンバー

CPSU-FORTE-S12S14G10

5 メンバー

7のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 2

今までの合計 1,558