メインコンテンツにスキップ

はじめに

Use this guide if the buttons of your Cobra SPX 5300 aren't working correctly.

  1. Remove the four 9.5 mm Phillips #0 screws from the back of the device. Remove the four 9.5 mm Phillips #0 screws from the back of the device.
    • Remove the four 9.5 mm Phillips #0 screws from the back of the device.

  2. Pull the black plastic back case off of the device. Pull the black plastic back case off of the device.
    • Pull the black plastic back case off of the device.

  3. Lift up the motherboard and lay it flat next to the device.
    • Lift up the motherboard and lay it flat next to the device.

    • Be careful not to sever the wires. The buttonboard is connected to the motherboard by the wires.

  4. Remove the windshield bracket mount.
    • Remove the windshield bracket mount.

  5. Remove the four 4.8 mm Phillips #00 screws from the buttonboard.
    • Remove the four 4.8 mm Phillips #00 screws from the buttonboard.

  6. Lift buttonboard to expose silver button plate.
    • Lift buttonboard to expose silver button plate.

  7. Remove the silver button plate by gripping one of the corners  and pulling up.
    • Remove the silver button plate by gripping one of the corners and pulling up.

終わりに

To reassemble your device, follow these instructions in reverse order.

ある他の人がこのガイドを完成しました。

Fanny Auad

メンバー登録日: 2015年09月25日

265 ポイント

2のガイドは作成済み

チーム

University of Tampa, Team 1-2, Whiteside Fall 2015 University of Tampa, Team 1-2, Whiteside Fall 2015人のメンバー

UT-WHITESIDE-F15S1G2

4 メンバー

5のガイドは作成済み

0 件のコメント

コメントを追加

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 341