はじめに

This guide will lead you through the steps for replacing the keyboard on your Brother PT-D200.

パーツ

パーツは必要ありません。

  1. Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.
    • Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

    コメントを追加する

  2. Remove the six AAA batteries.
    • Remove the six AAA batteries.

    コメントを追加する

    • Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.

    コメントを追加する

    • Close the back cover and then flip the device over and separate the top half from the bottom half as shown.

    • Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.

    コメントを追加する

    • On the top portion of the device there are four grey clips locking the faceplate in place. The two top clips are circled in the image. The two others are located in the other corners of the device.

    コメントを追加する

    • Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.

    コメントを追加する

    • Peel off the rubber keyboard of the device.

    コメントを追加する

まとめ

To reassemble your device, follow these instructions in reverse order.

[deleted]

メンバー登録日: 2014年01月24日

301 ポイント

3のガイドは作成済み

コメントを追加する

統計データを表示:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 248