メインコンテンツにスキップ

このドキュメントから答えを探す

全14 ページを読み込んだので、あなたが読む必要はありません。今すぐ質問して、答えを手に入れましょう。

Bambu Lab A1 User Guide

User guide 14ページ · 2.49 MB · PDF

Network Setting

Image

Network Select Wi-Fi Connect to Network This step could enable you to send printing from phone, computer. Skip →

① Follow the instructions until you see this screen. Press “Select Wifi” to search for available network.

Image

< Wi-Fi Passcode OK ABC Z X C V b n m 12@

③ Input the passcode, and then press "OK".

Image

< Select Wi-Fi (only for 2.4G) Wi-Fi SSID 1 Wi-Fi SSID 2 Wi-Fi SSID 3 Wi-Fi SSID 4

② Select your preferred network.

Printer Binding

① Download the Bambu Handy App. Register and log in to your Bambu Lab account.

③ Follow the instructions on the screen to complete the initial calibration. It is normal to have vibration and noise during the calibration process.

② Use Bambu Handy to scan the QR code on the screen, and bind your printer to your Bambu Lab account.

Image

Download Bambu Handy < Login the account Use Bambu Handy App to scan and log in This step could enable you to send printing from phone, computer and Makerworld!

Image

Bambu Lab

Recommended for beginners Bambu Lab X1 Series

9:41

No Device

Scanning Printers

9:41

Add Printer

Name Your Printer A1 (3dp-111-111)

Would you like to bind the Printer Bamboo Lab A1 with current account?

Bambou Lab A1 Bambu Lab

A1 (3dp-111-111)

Name Your Printer A1 (3dp-111-111)

Bambu Lab

A

Image

Bambu Lab

① Orient spool installation according to the filament winding direction. (as shown in the diagram)

$ ^{*} $Warning

① The AMS lite supports spools with a width of 40-68 mm and an inner diameter of 53-58 mm.

② Avoid using AMS lite to print flexible materials, including TPU, TPE, or absorbent PVA. Avoid using materials that are too hard (too high modulus) or too brittle (not enough toughness), including third-party fiber reinforcement materials (PA-CF/GF, PET-CF/GF, PLA-CF/GF, etc.). Please use external spool placement to print these filament.

Image

40-68 mm

Image

Bambu Lab 53-58 mm

Note: Press the release button to disengage drive motor if filament stuck.

iFixitに登録して、完全版修理ガイドを入手しましょう (14ページ)

ボットをブロックし、iFixitを人間のためのサイトとして維持するために、無料アカウントの登録が必要です。

統計データ:

過去 24時間: 0

過去 7 日: 19

過去 30 日: 19

今までの合計 19