Setting Up Your Dell PowerEdge Server Using Dell Lifecycle Controller
Setting Up Your Dell PowerEdge Server
Using Dell Lifecycle Controller
i
NOTE: A NOTE indicates important information that helps you make better use of your product.
△
CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem.
△!
WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
© 2016 Dell Inc. All rights reserved. This product is protected by U.S. and international copyright and intellectual property laws. Dell and the Dell logo are trademarks of Dell Inc. in the United States and/or other jurisdictions. All other marks and names mentioned herein may be trademarks of their respective companies.
Contents
Chapter 1: ..... 4
Setting Up Your Dell PowerEdge Server Using Dell Lifecycle Controller.....4
Related Dell products.....8
Topics:
Setting Up Your Dell PowerEdge Server Using Dell Lifecycle Controller
Setting Up Your Dell PowerEdge Server Using Dell Lifecycle Controller
Dell Lifecycle Controller is an advanced embedded systems management technology that enables remote server management using integrated Dell Remote Access Controller (iDRAC). Using Lifecycle Controller, you can update the firmware using a local or Dell-based firmware repository. The OS Deployment wizard available in Lifecycle Controller enables you to deploy an operating system.
This document provides a quick overview of the steps to set up your PowerEdge server using Lifecycle Controller.
NOTE: Before you begin, ensure that you set up your server using the Getting Started Guide document that shipped with your server.
To set up your PowerEdge server using Lifecycle Controller:
- Connect the video cable to the video port and the network cables to the iDRAC and LOM port.
IOI iDRAC
Figure 1. Video port, iDRAC port, and Lights Out Management (LOM) port
- Turn on or restart the server and press F10 to start Lifecycle Controller.
PowerEdge FC630 BIOS Version: 0.4.3 iDRAC IP: 10.94.195.46 Lifecycle Controller Requested
Entering Lifecycle Controller...
Figure 2. Starting Lifecycle Controller
NOTE: If you miss pressing F10, restart the server and press F10.
NOTE: The Initial Setup Wizard is displayed only when you start Lifecycle Controller for the first time.
- Select the language and keyboard type and click Next.
DELL Lifecycle Controller Help | About | Exit Initial Setup Wizard Step 1 of 5: Language and Keyboard Selection Select the display language and keyboard layout options below. Language English Keyboard Type United States Cancel Next
Figure 3. Language and Keyboard Selection page
- Read the product overview and click Next.
