修理を始めるには コミュニティ ストア

250回答 すべてを表示

オプション

Digitizer replaced / Touchscreen does not work

Hello -

I had an iPad 2 WiFi with a cracked digitizer/glass. I ordered a replacement digitizer/front glass from a leading iPad parts company (no junk). I removed the old digitizer/glass and installed the new one. Everything went flawless and the video connector from the new digitizer is perfectly inserted into the board connector. All of the buttons work BUT I can not get the new digitizer to work. I even installed a second one I purchased just to make sure but I can not get the digitizer to work. Any suggestions? Thanks!

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 2
コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

I have resolved the issue...thankfully. I have repaired electronics my whole life but it seems that the two-prong video connector cable off of the digitizer connects to the motherboard UPSIDE DOWN. I know that sounds strange, but if your digitizer does not work after replacing it, reverse these cables and put them in what most would think to be upside down (which in this case, is correct).

このアンサーは役に立ちましたか？

はい いいえ
スコア 3

2 件のコメント:

what do you mean upside down?

how do you fix it?

i have the same problem

さんによる

This has resolve my issue!!

さんによる

コメントを追加

オプション

I had same problem, make sure the white perferated line is facing up, my problem is half of the touch screen is unresponsive. Any help, something i did? Bad screen?

このアンサーは役に立ちましたか？

はい いいえ
スコア 2
コメントを追加

回答を追加する

rick さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 6,426