評価: 297
2
9
I have these two components dropped off from logic board when trying to upgrade blade SSD and ram, see pictures attached. Anyone knows what are they for? And will the logic board still work without having them soldered back? Thanks.
評価: 33.8千
26
38
33
Those are capacitors. Specifically 6.3 Volt 150 microfarad capacitors.
I won’t get in too much depth about their overall function (unless you want). But in this case your iMac probably will not turn on without them. It might. But I am rather doubtful. Not only does the schematic note them as “critical,” they are part of the circuit used to generate a specific voltage rail that is necessary for power on.
Sometimes capacitors can be left off, it depends on what their purpose in the circuit is. It won’t do any hard to try and boot it up without them, but I don’t expect you to get far.
Luckily, as far as components that could have popped off the board, these are big enough that soldering them back (or getting replacements soldered on) shouldn’t be too difficult with a little solder know how. It looks like they might have just had some brittle old solder joints that decided to give up the ghost during the repair. If the capacitors themselves don’t seem to be bulging, or damaged in any way, you can probably just solder them right back on without any harm.
このアンサーは役に立ちましたか？
@Alisha Yeah, that is what I thought too. Do you know where I can buy the replacement for these two capacitors as the pins from each were broken too?
@lovecd The two major vendors I typically use for electronic components are digikey or mouser. Either would have something akin to what you need. I tried to snag the size from the schematic so I could get you a direct link, but no such luck.
These particular caps are aluminum polymer, but you can probably get away with another type if you need to as long as the specs are the same.
@flannelist, should I look for the one with the following specs?
6.3 Volt 150 microfarad capacitors
Thanks,
過去 24時間: 0
過去 7 日: 1
過去 30 日: 29
今までの合計 29
