修理を始めるには コミュニティ ストア

High-end gaming laptops produced by Alienware (a subsidiary of Dell since 2006).

162回答 すべてを表示

オプション

X14 r1 Screen goes black when open past certain angle,probs LCD cable

i have an alienware x14 laptop and the screen is now black when it is open past a certain angle. i think it has to do with the display cable being loose or pinched and I dunno how to fix it myself. I tried, but the official guide was not seemingly consistent with the interior layout of the laptop and i couldnt get some of the screws out. am i screwed or is there a better way to do this besides checking in with a PC repair shop?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
2 件のコメント

I have the same issue? Did you happen to get this fixed?

さんによる

@davidk37190 I'm planning on getting it fixed, it seems i need the display assembly replaced considering how the computer's designed. it's a couple hundred USD for a fix right now but i'm a big procrastinator. fingers crossed to getting around to it

さんによる

コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

Hi @henrysutherland

Is this the service manual that you were looking at that didn't match the layout in your model?

If not, go to p.37 to view the procedure for installing the display assembly as this shows the routing of the display cable, between the motherboard and the display assembly.

Reading through it it seems that if it isn't lined up correctly then damage to the cable could occur.

This is what seems to be happening with your model i.e. damaged cable, given the symptoms that you described.

The manual also states that the display assembly is a complete module - see Note: Removing the display assembly on p.35, so it seems that if the cable is damaged, then it may be difficult to source a separate cable or even open the display assembly to access the LCD panel cable connector to replace it.

このアンサーは役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

回答を追加する

Henry Sutherland さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 4

過去 30 日: 34

今までの合計 122