メインコンテンツにスキップ

2014年9月19日に発売されたiPhone 6の修理情報とガイドです。モデル番号 A1549、A1586、A1589。

4994回答 すべてを表示

iPhone 6 Dying at 4% after battery replacement!

I have an iPhone 6 and it randomly started to bootloop.I knew it was a battery issue, So I went into battery health and it was just loading.So I went to the same place I got my phone battery replace and they replaced it again.Everything was going great until my iPhone was at 4% and it randomly died.I plugged it in but instead of showing the low battery logo it showed the apple logo and it was at 4% instead of 1%.What should I do?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
1件のコメント

Have You calibrated the battery?

さんによる

コメントを追加

1 件の回答

最も参考になった回答

Try calibrating the battery

Run it down until it shuts off,
Then charge it up to 100% uninterrupted then keep it plugged in for 2 more hours,
Run it down till it shuts down,
And finally, charge it uninterrupted to 100%

このアンサーは役に立ちましたか?

スコア 1

7 件のコメント:

I was going to mention calibrating the battery as above but I’d run it down to 10% and then charge again rather than letting it die. But do what @beanman56 says.

さんによる

@strongbow - It’s very necessary for the calibration to be done completely as it’s said,

Otherwise it’s probably gonna be the same

さんによる

To be honest, they don't need calibrated at all. Calibration was for the old nickel based batteries. The newer lithium based batteries don't need calibrated. They are basically plug and play. I wouldn't worry about dying at 4%, it should work itself out over a few charges.

さんによる

@strongbow - Then explain why ifixit says to calibrate the battery

さんによる

Ask them? I’m not trying to explain someone else’s mistakes.

https://discussions.apple.com/thread/789...

さんによる

2件以上のコメントを表示

コメントを追加

回答を追加する

Keshawn Vasugan さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 3

今までの合計 83