メインコンテンツにスキップ

2014年4月のアップデートによりアップルの13インチMacBook Airはデュアルコアi5またはi7プロセッサーの更新とわずかなバッテリー性能の向上がされました。

316回答 すべてを表示

Trac pad connector MacBook Air connector for new cable popped off

small black flip up and down cable connector which locks cable in place (plastic) broken . I am replacing cable can I tape in place in lieu of trying to get the connector to work?

Thanks in advance, Rich

Update (06/19/2022)

Block Image

This is the small plastic clip that secures the cable on each end

Sorry had a problem with the photo. As you can see the fastener is tiny and was wondering if I could buy another or tape the cable in place. Thanks!

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
1件のコメント

@poohbeard you can try but most likely it will not provide enough force to maintain the contact. You can try and repair your connector (depends how broke, broke is) or you may have to solder a new connector on. Post some pictures of the damage with your QUESTION so we can see what you see iFixitでの質問に画像を追加する方法

さんによる

コメントを追加

1 件の回答

最も参考になった回答

Here's the trackpad connector Trackpad Flex Connector I would order a few just in case!

You might be able to carefully unsnap the latch hinge pins on each side by carefully bowing the latch piece. Then you can do the same with the part to then snap into the logic board connector. If you've damaged the lower part of the connector you'll need to desolder the old one and then solder on the new one.

This is a bit tricky! So unless you've soldered logic boards before its best to let someone with the deeper skills do it for you.

このアンサーは役に立ちましたか?

スコア 1

1件のコメント:

Thanks for the link I think I can do as you suggested as the lower part is not damaged. My old eyes need some help with these small pieces :) Really amazing how fragile all these parts are. Thanks, Rich

さんによる

コメントを追加

回答を追加する

richard hamilton さん、ありがとうございました!
統計データ:

過去 24時間: 2

過去 7 日: 2

過去 30 日: 4

今までの合計 49