修理を始めるには コミュニティ ストア

1.7GHz デュアルコア Intel Core i5（Turbo Boost使用時最大2.6 GHz）3MB L3キャッシュ

139回答 すべてを表示

オプション

820-3208-A Board no green light

Hello Guys,

I have a problem that I would like some help with on this 820-3208-A logic board I’m working on. The board looks really clean and there was no water damage,. However, there was some corrosion around U6990 chip and there is no green light on the magsafe. After cleaning the corrosion and replacing the U6990 chip I only get 2.74 V on pins 2 and 4. Pins 6 and 8 both have 15.50V going in. I checked for a short to ground on the pp3v42_g3h and did find a small drop to ground. I then felt around and noticed the SMC is really hot to touch. Please tell me that the SMC is not bad!!!!!

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

Have you checked for corrosion under SMC? That seems like the most probable cause.

このアンサーは役に立ちましたか？

はい いいえ
スコア 2

4 件のコメント:

Ben is right. Remove the SMC and see if PP3V42_G3H comes back.

さんによる

Thanks Ben, I will check but I'm fairly certain that the smc area is very clean. Just don't understand why I would be getting any voltage at all if there is a short on that line on the smc? I get 2.7V! Dont want to mess with smc if I can avoid it!!!

さんによる

Hey guys is it possible that u5010 (SMC reset-L) is shorted and causing the smc chip to heat up? Still baffling!

さんによる

@Roger What do you get on PPBUS_G3H?

さんによる

コメントを追加

回答を追加する

Roger さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 11

今までの合計 305