評価: 23
2
Long story short, my logic board went out. Started smelling like burnt electronics. Pulled the board out, and found one of the capacitors on the back side of the logic board was melted.
It seems like it would be fairly easy to replace, I just don’t know what capacitor it is, or where to find one. I know it looks like a D2E Case Tantalum capacitor, but beyond that, I’m not sure.
Thanks in advance!
この質問は役に立ちましたか？
評価: 479.6千
35
329
971
The Cap is one of a group: C7370 which is a 68UF 20% 16V Poly-Tantalum in a D2E case
Here’s one source: Mouser
このアンサーは役に立ちましたか？
Thanks a ton! I do have a follow-up question. (see second picture above) The blown capacitor is opposite the metal block (R36 446 RA7). I don't know exactly what that component is. Can't tell if they're connected or not.
Just wondering if there's anywhere I should check for a short or anything before replacing the capacitor?
Thanks again!
Also, the link seems to point to the wrong thing? It pulls up a 6.3V 220UF B case capacitor?
Sorry meant the PDF here Solid Tantalum Surface Mount Chip Capacitors, Molded Case
The R36 is an inductor coil Shielded Power Inductors
Thanks for the clarification!
評価: 23
2
Found this question/answer that led me to the right replacement capacitor
このアンサーは役に立ちましたか？
過去 24時間: 3
過去 7 日: 6
過去 30 日: 28
今までの合計 602
