評価: 37
2
1
Hi all,
I just replaced my LCD and when I boot up my phone the display seems to work but after 1 or 2 seconds the backlight shuts off. The screen is fully functional; touch works as well as the pixels. I can only see the pixels by holding the screen at a 45 degree angle while shining a flashlight.
Any solutions? Did I connect anything wrong?
評価: 159.8千
11
191
368
I've had a very similar symptom happen on an iPad 2 for example.
I fixed it by cleaning the screen connector on the board with a soft bristle brush and 99% isopropyl alcohol, wasn't making a full connection so backlight would shut off because it couldn't get full power.
このアンサーは役に立ちましたか？
That doesn't seem to work. Also I forgot to mention that the backlight of the broken screen is working when I try that one.
評価: 13
1
Found out that one pin was stuck in the motherboard connector. It was not making contact with display connector.
Check the pins under the microscope.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 1
過去 30 日: 9
今までの合計 1,474
1件のコメント
Hey, have you found the solution. I have the same problem. It works just with original display and no other.
Doom Bass さんによる