メインコンテンツにスキップ

2014年9月19日に発売されたiPhone 6の修理情報とガイドです。モデル番号 A1549、A1586、A1589。

4994回答 すべてを表示

iPhone 6 Logic board not booting. DCPS shows 200 mA draw

Slightly water damaged iphone 6 totally dead.

removed the logic board, all the shields, & cleaned in ultrasonic solution branson EC, …

Found no shorts anywhere( vcc main, pp_cpu, pp_gpu, var, sdram, …). Also all the rails’ voltages seem to be in range.

Connected the Logic board only to DCPS. It does not even boot but draws 200 mA.

PMIC gets warm but not hot.

help would be appreciated!

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 0
コメントを追加

2件の回答

ベストアンサー

Did you check ALL of the PMIC outputs or just the main ones? A faulty subsystem can pull the whole system down as well and it is often overlooked. If they all check out, then check the main subsystems that aren’t powered by the PMIc, such as MESA,CHESTNUT, BACKLIGHT. Then check the I2C lines to insure they are balanced and within range and take a look at the PMIC Reset lines (those that can be probed) to see if the problem is there.

Finally, check the BBPMU outputs as well as a damaged BB system will impede the phone from booting.

Also, what areas of the board were more corroded, that could give you some clues about where the damage actually is.

このアンサーは役に立ちましたか?

スコア 2

4 件のコメント:

Update:

PP 1V8 SDRAM rail reads 0.52 V

???

さんによる

Check that power rail with the phone unpowered in diode mode to see what reading you get. There may be a partial short that you will need to elucidate.

さんによる

Found the shorts:

Backlight driver —> 0.18 A

U5302_RF —> 0.02 A

Both are removed.

No booting ( from zero goes to 0.12 A & repeat itself)

DFU recovery on iTune recognizes the board but haven’t gone farther. (Did not recover). Trying not to loose data.

?

さんによる

PP 1V8 SDRAM. Ow reads correctly 1.8

さんによる

コメントを追加
最も参考になった回答

Does it show 200ma when dcps is connected or after button press. If it's after button press I would check tristar

このアンサーは役に立ちましたか?

スコア 2

2 件のコメント:

It draws 200 mA before pressing the button.

After button press just a blip & stays on 200 mA.

Could it be a faulty PMIC?

さんによる

Before removing the pmic remove Tristar and then see what it does on dc

さんによる

コメントを追加

回答を追加する

Hama さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 373