修理を始めるには コミュニティ ストア

2016年9月16日に発売。モデル番号は1660, 1778で GSM かCDMA があり。/ 32、128、 256 GB / 色はローズゴールド、ゴールド、シルバー、ブラック、ジェットブラック

2264回答 すべてを表示

オプション

Lightning Port Replacement Problems - Taptic, Service, Battery

UPDATED

Hi all! I’ve seen some questions asking for solutions to similar problems but not 100% like mine.

I replaced the charge port in an iPhone 7 and after the repair I am having a number of issues.

  1. Taptic Not Working - no vibration response to home button presses or silent switch flicks.
  2. Service constantly “Searching” - no IMEI listed in settings either
  3. Battery icon reads 1% and not charging while connected. Stuck a new battery in that I know has charge and it’s still reading at 1% and no lightning symbol to show charging status.

I know the port works to an extent because the phone turns on when I plug it in but I’m experiencing all of the above issues. Anyone have the same experience and know a solution? I’m ordering a new premium charge port and trying that out but I wanted to see if anyone had any other ideas.

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

A few thing to diagnose for the following:

  1. Taptic Not Working
  2. Are you referring to the vibration feedback that you get when pressing the home button, flicking the vibrate / silent switch?
  3. Service constantly “Searching”.
  4. Check if IMEI is displayed in dialer by typing *#06#. Also check if IMEI and modem baseband is displayed in settings > general > about phone. Another thing to check is Sim detection to make sure it isn't permanently stuck on searching.
  5. Battery icon reads 1% and not charging while connected.
  6. For this one check if the connector for the battery cable is seated in fully. Other things to check would be the components around the connectors on the board for any pry damage. It could be that some components on the board may have gotten prayed off or damaged.

このアンサーは役に立ちましたか？

はい いいえ
スコア 2

3 件のコメント:

I appreciate the input. Will look into this stuff tomorrow when I’m back at my store. Thanks!

さんによる

As for Taptic. Was not responding to home button, did not actually check the silent switch.

さんによる

No IMEI issue means the phone has a major board-level fault. If you want to get that fixed you'll need to take it to someone that does board-repairs on iPhones.

さんによる

コメントを追加

オプション

Did you ever resolve this issue? I’m having the same problems as mentioned above after changing my lighting port.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0

2 件のコメント:

There is a rampant defect on the 7 and 7 plus phones where one or more pads which provide connection for the baseband chip become loose which causes the no IMEI / stuck on searching fault.

Sadly even taking the logic board out of the phone or any tension on the board can cause this.

さんによる

Thanks for your reply Ben. I take it it’s fixable if I take to someone who can do board repairs? Are the other two faults I’m experiencing (1% battery & no vibration) related or are they separate faults? Many thanks, Matt.

さんによる

コメントを追加

回答を追加する

Xander さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 196