修理を始めるには コミュニティ ストア

2014年9月19日に発売されたiPhone 6の修理情報とガイドです。モデル番号 A1549、A1586、A1589。

4994回答 すべてを表示

オプション

iPhone turns on, but after Apple logo it turns black but remains on.

Hi there,

My girlfriend dropped her phone kinda bad, so the screen was completely dead with only backlight showing any sign of living. However, I replaced the screen and then I tried to turn it on, and it didn’t start up..

with the charger in, and no home button-cable connected it shows the Apple-logo and then fades to black in a kinda’ pixelated way, but remains on. Backlight is showing, but when I try to start it with the home button-cable attached it won’t turn on..

I have changed the battery, sensor flex, LCD, flex cable for home button, but it still turns to black after the Apple logo shows.

It shows some gray stripes upwards on the screen, just on the top before turning to black..is there a way to fix this?

I can’t make a backup either because my computer ain’t trusted, and neither is her own.. (big miss..)

best regards,

JL

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
1件のコメント

Is it detected by iTunes in recovery mode or in normal mode or not at all? That is your next step.

さんによる

コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

Is the phone recognized by iTunes? You say it’s not trusted so it sounds like iTunes does see the phone, but you can’t get past the trust issue.

At this point, you see the backlight, you see the display for a few moments (logo), you’ve tried a new battery and screen. It pretty much all points to a logic board issue, assuming the replacement parts are all in good working order. It’s hard to remote diagnose this kind of problem and I believe you have tried pretty much everything a DIY fixer can try. The hard impact probably damaged some soldered connections under one of the IC’s or dislodged some components somewhere. You should have this looked at by a repair shop that does micro-soldering repair.

このアンサーは役に立ちましたか？

はい いいえ
スコア 2

1件のコメント:

Probably the issue as you say, thank you for your time and help! :)

さんによる

コメントを追加

オプション

check the lcd connection to the motherboard, plug nothing but the lcd and digitiser flex, to see what happens. if that doesnt work try a different lcd

このアンサーは役に立ちましたか？

はい いいえ
スコア 1
コメントを追加

回答を追加する

Jesper Linder さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 59