I bought the iFixit pro kit but I don’t know which screw should I use it says 1.2 or 2.8 or what ever but I can’t find it like it says under the screw in the ifixit kit like T5 or P2 or 2 or 0.5 if I could know that. it would be awesome .
評価: 159.8千
11
191
368
You use P2 (Pentalobe 2) for taking the two bottom screws near the charging socket to allow you to lift up the screen.
Then I use a razor blade on the left and right hand side deep in between the screen’s plastic frame and iPhone housing to loosen the clips holding the screen down.
I find this better to do as sometimes when using a suction cup it doesn’t lift up the screen properly and instead separates it from it’s frame.
Most of the screws inside are phillips head (PH000 fits great, PH00 works but is a bit larger). The larger ones with the plus and a hole in the middle can be taken out by using the flathead ‘1’ screw.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 0
過去 30 日: 1
今までの合計 28
