Had a iPad mini 3 come back for a loose home button re-adjusted and adhered the button back. Went to test the device attempts to boot x2 then red screens
What I have tried
- unplugging anything and everything that's not soldered down minus the LCD
- cameras front and rear
- power button
- digi
- home button
- aux
- antennas
- coaxel cables
What I have not tried
- restoring
Anything would be helpful thank you for your time ahead of time
評価: 159.8千
11
191
368
Have you checked charger port if it's loose? Sometimes you may need to tighten the screws up for the charger port.
Red screen can also mean the tristar (U2 charging) chip being bad or NAND chip failure.
Might need to do a restore but that will wipe data so if data is needed leave restore for last resort.
このアンサーは役に立ちましたか？
過去 24時間: 0
過去 7 日: 3
過去 30 日: 6
今までの合計 67
1件のコメント
Update1:
- tried new battery x2
- took out sim card
- tested for boot without LCD
Mitch Kelly さんによる