修理を始めるには コミュニティ ストア

2014年9月19日に発売されたiPhone 6の修理情報とガイドです。モデル番号 A1549、A1586、A1589。

4994回答 すべてを表示

オプション

No backlight after unlock phone (backlight work during boot)

Hi guys,

recently i repaired iPhone 6 water damaged.

I replaced PMIC, after then phone boot but there are not backlight and touch. I replaced:

- backlight IC

- backlight capacitors

- touch ICs - MESON, CUMULUS

- LCD IC - CHESTNUT

Now after press power button, phone boot with backlight and work normal. When i lock phone, LCD goes off, but when i want unlock phone there are not backlight. Touch and LCD work.

My question is:

Where can be problem? It look, backlight driver do not receive ENABLE signal after booting and do not want work.

Can be here problem with

45_AP_TO_PMU_AND_BL_DWI_CLK

45_AP_TO_PMU_AND_BL_DWI_DO

?

For what is there this bus?

Sorry for my bad english :)

Thanks

@refectio

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

Those two lines are part of the I2C bus. You will want to check them to insure they are not shorted. I would also look at pin B1 of U1502. That is the Hardware Enable pin. I don't know enough about the internal logic of these IC's to say what could be causing this.

このアンサーは役に立ちましたか？

はい いいえ
スコア 2
コメントを追加

オプション

I fixed so many backlights specially on 6 and 6s. Normally it's filter

But recently I d given iPhone 6s with very low backlight

Checked all caps, filter, diod, coil etc. Everything seemed fine so I changed backlight ic(u2040) no luck

And than I changed main pm ic and problem has gone.

このアンサーは役に立ちましたか？

はい いいえ
スコア 1

2 件のコメント:

How do you know that you must replace PMIC? Should i use multimeter?

さんによる

yes check all the voltage and most importantly recistance of the components.

But you said you have changed it didn't you?

But again your phone is the water damage. Could be anything man.

Have you checked any short?

さんによる

コメントを追加

回答を追加する

Tomas さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 3

過去 30 日: 7

今までの合計 481