解決済み: Power Button Wiring Mac Mini 2011 - Mac Mini Mid 2011

Power Button Wiring Mac Mini 2011

Got a Mac Mini in for the fan connector replacement which has been replaced, however the wires going into the power button from the logic board have been pulled off by the customer when fitting the dual hard drive enclosure.

I'd like to strip and resolder the wires to the power button PCB, but could anyone confirm which wire goes where (black and a grey one), since I haven't got another one to hand, and it's possible they are in the wrong position.

Thanks.

回答がありました！ 回答を表示同じ問題があります

この質問は役に立ちましたか？

はいいいえ

スコア 1

投稿日: 2017年8月17日

オプション

I don't think it matters, which goes on what side.

Double check using a Ohm meter to see if one side of the button contacts is chassis ground, if neither are it makes no difference.

このアンサーは役に立ちましたか？

はいいいえ

スコア 2

3 件のコメント:

Thanks, I'll check once I'm in again on Saturday. I'm sure it said something like 'PWR1' and 'PWR2', but I only saw this when I peeled back the tape to see the wires were damaged, so I'm probably wrong

Reece さんによる2017年8月17日

Its a soft switch - Momentarily contact blister switch, which is sensed within the power supply to kick the power supply on. Just like the iMac's

Dan さんによる2017年8月17日

Thanks. Grey wire (gnd) goes on the left side and the black wire on the right side. Works fine now :)

Reece さんによる2017年8月19日

コメントを追加

Mac Mini Mid 2011

Power Button Wiring Mac Mini 2011

1 件の回答

回答を追加する