メインコンテンツにスキップ

THINKPAD T520。トップレベルのパフォーマンスとポータビリティ。

17回答 すべてを表示

On startup it beeps and has blackscreen. help!

So when i start my computer it has a black screen and beeps, its 3 beeps followed by another 3 then followed by 1. I suppose its like a RAM issue from what ive read but i dont know if the solutions apply to my computer. Its my school comp btw so need it fixed ASAP :) (not very technical)

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア 2
1件のコメント

2 beeps pause 1 beep then repeats

さんによる

コメントを追加

4件の回答

ベストアンサー

Trak, you can try reseating(remove and reinsert in case of bad connection) the Ram/memory in your computer to see if that fixes the fault your having. I will post a link on how you access the Ram/memory to enable you to try this. Good luck .

I hope this helped you out, if so let me know by pressing the helpful button.

http://www.storagereview.com/lenovo_thin...

このアンサーは役に立ちましたか?

スコア 5

6 件のコメント:

I'm having the same issue as the original post but it happens after i try and install a new trackpad. The error only happens while the trackpad is plugged in though

さんによる

@oatmeal0719

Have you tried resetting the BIOS?

さんによる

@aactech

I have not. I'm not entirely sure how to reset the BIOS from a black screen, or if resetting it would work before putting the trackpad back in

さんによる

@oatmeal0719

Take out main battery. Discharge power by pressing On/Off button. Open case and unplug the CMOS (they call it "backup battery here). Here's the diagram from the manual.

https://support.lenovo.com/nz/en/solutio...

or download entire manual:

https://www.manualslib.com/download/4933...

さんによる

I tried everything for the above comments and my screen remain black and the beeping continues. The power light flash and the "caps lock" light is on. I don't know how to fix this. Please give light

さんによる

1以上のコメントを表示

コメントを追加

This should be a question but https://support.lenovo.com/us/en/solutio... those are all the codes

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

John hall is right about the track pad wire my track pad comes off easily and is snapped off the wire. I tucked the wire into the laptop and it started touching something I’m guessing metal which caused it to short circuit I think. I just had the get out the wire.

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

I have a Lenovo X1 Extreme Gen 1.

Got the 0282 beep. Memory module or system board error. I tried swapping out the memory didn't work. System board was above my pay grade. I'm glad I found this thread because I disconnected the touchpad and it works now. Thanks John Hall et al.

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

Traktorsven さん、ありがとうございました!
統計データ:

過去 24時間: 20

過去 7 日: 81

過去 30 日: 369

今までの合計 66,131