評価: 1
1
I replaced my broken iPad Air 2 LCD Screen and Digitizer with a new one.
But when I tried to turn on the device, after the repair, it will not start.
I used an iOpener (heated it in microwave for 30 seconds) and a plastic spudger, and followed the teardown video. I'm not sure where I screwed up. Any help would be great.
Thanks.
評価: 159.8千
11
191
368
Did you try unplugging the battery and performing a hard shut down? You can do it by holding power and home button for about 10-15 seconds.
このアンサーは役に立ちましたか？
I tried it, but nothing happens.
評価: 1
1
I've found out my problem. I tore up the small rectangular piece (on the left side of home button) that is soldered on.
このアンサーは役に立ちましたか？
I'm about to do this repair. Does this have to soldered on to the new screen?
Yes. And don't lose it.
過去 24時間: 0
過去 7 日: 2
過去 30 日: 4
今までの合計 217
1件のコメント
I've found out my problem. I tore up the small rectangular piece (on the left side of home button) that is soldered on.
Phil さんによる