メインコンテンツにスキップ

ハードドライブもしくはハードディスクに関する修理情報です。ハードドライブは磁気データ記憶装置です。 低コストでデータ密度が高いため、ほとんどのデスクトップ、ラップトップ、およびサーバーで使用されています。

146回答 すべてを表示

My power cable pin is burnt

hi frnds.... my hard drive is of 250 gb sata .segate.... the power cable pin of the hard drive is burnt(i think due 2 loose connections)....is any where can i fix it and get it into work...or should i buy new one...please answer me frnds....

この質問に回答する 同じ問題があります

この質問は役に立ちましたか?

スコア 0
1件のコメント

please check to see if your drive is a SATA or IDE/ATA

さんによる

コメントを追加

2件の回答

最も参考になった回答

If the connections are badly damaged such that cleaning is not possible, then the connector will need to be replaced. Doing that may be a bit tricky without the proper soldering tools, however. Another possibility is to replace the entire drive circuit board with that from an identical model. Like Eric said, also be sure to check and make sure the cable is good, or else you may cause more damage.

このアンサーは役に立ちましたか?

スコア 1
コメントを追加

It is most likely burnt because of a poor connection. Clean the pins/plug, and make sure they make good contact, and the drive maybe it is salvageable.

If you replace the drive, be sure to clean the plug/cable, and that it makes good contact or you may have the same failure again.

このアンサーは役に立ちましたか?

スコア 0
コメントを追加

回答を追加する

pranay raj さん、ありがとうございました!
統計データ:

過去 24時間: 1

過去 7 日: 1

過去 30 日: 3

今までの合計 2,647