修理を始めるには コミュニティ ストア

2.16 or 2.33 GHz Core 2 Duo processor

268回答 すべてを表示

オプション

How much thermal paste to apply?

I've recently fully stripped a water (coffee) damaged MBP to give it a good clean (including removing the thermal paste).

Now im in the rebuild stage and come stuck regarding the replacement of the thermal paste. Basically, how much do i need to apply on each of the chips?

Because when i removed the logic board, the paste had overflowed in different amounts over the chips on to the green circuit board.

The reason i ask, i remember when my had to replace the thermal paste on my old PS3, too much paste was considered just as bad as too little. Is that the case here?

この質問に回答する 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア -1
コメントを追加

1 件の回答

フィルタ：
参考になった順 新しい順 古い順
最も参考になった回答

オプション

taff, just to much would be just as bad since it would block the heat transfer. Anyhow, take a look at this great guide. Hope this helps, good luck.

このアンサーは役に立ちましたか？

はい いいえ
スコア 2

5 件のコメント:

Thanks oldturkey03 for your quick reply.

I did view the guide that you linked before I posted this question. In hope that it would answer my question. But unfortunetly, it only states to apply the paste with your finger and it doesn't give the amount to apply :(

さんによる

Yes, I see what you are saying. Since most of us on here use a lot of Arctic Silver thermal paste, I recommend using the instructions posted by them on here. The instructions should also hold true for other manufacturers. Hope this helps, good luck.

さんによる

Thanks for the new link. After a bit of searching, I managed to find the right page.

I've just had a thought. What if I put a dollop of paste in the centre of each chip, then when I place the logic board back on and secure it, will that not spread the paste to the correct thickness?

さんによる

Yes it will. A bit of paste the size of a pea should do

さんによる

Excellent...thanks

さんによる

コメントを追加

回答を追加する

taff さん、ありがとうございました！
統計データ:

過去 24時間: 0

過去 7 日: 1

過去 30 日: 6

今までの合計 810