修理を始めるには コミュニティ ストア

iPhone 4のCDMA版モデルです。修理はそのままパーツに作業をしますが、フロントガラスとLCDはユニットで交換しなければなりません。16もしくは32 GB / Model A1349。

20回答 すべてを表示
締切られた回答

オプション

no power after replacing screen

i followed the ifixit guide to replace the screen. Upon completion, i went to turn phone on and it would not turn on. Thinking that i did not properly connect battery i re-connected the battery. tryed to turn phone on again, and with much dismay still no power. hooked the phone charger up to it and it vibrated but still no power. i am at a loss as what to do or what to check. and yes i made sure that the sleep switch was off.

回答がありました！ 回答を表示 同じ問題があります

この質問は役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

2件の回答

フィルタ：
参考になった順 新しい順 古い順
ベストアンサー

オプション

Sorry if this post came up more than once, my internet kicks out every time i submit.

If the phone vibrates, its got power. Its 1 of 3 things.

1. The LCD you bought was shipped broken, the testers are cheap. Wouldn't be bad if it saves you $40/$50. Please don't buy cheap screens. You'll notice the difference in the display.

2. The flex cable is loose. Take it apart, disconnect and reconnect the cables and make sure they're snapped down. They should snap, sometimes there's a little yellow tape on the LCD that gets moved from holding down another component. Make sure the motherboard and the cable itself has nothing in or around it.

3. You probably ruined the LCD flex while installing the glass. Those cables are thin, and can easily be ruined. Hopefully its not the case. I've been repairing phones for years, i've accidentally ruined a few while rushing.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加

オプション

I had this same issue. If you are positive the new screen is not the issue. The problem is definitely because the phone is outdated and needs to be updated.

このアンサーは役に立ちましたか？

はい いいえ
スコア 0
コメントを追加
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 0

今までの合計 276