メインコンテンツにスキップ

Model A1138 / 1440x960 screen resolution

85回答 すべてを表示

Do I need to add thermal compound?

Hi

I am about to perform an installation of a new logic board in my machine, and when I pulled the old one out, I noticed thermal compound was on the heat sink under the ATI Graphics module, as well as under the processor. I bought a used board off eBay and it there is compound on the processor and graphics module in the photo on the advert, however, there is absolutely no mention of this on the iFixit guide? The guide only mentions adding thermal compound to the heat sink where the processor is.

Thanks ;o)

回答がありました! 回答を表示 同じ問題があります

この質問は役に立ちましたか?

スコア -1
コメントを追加

1 件の回答

ベストアンサー

Here's all the information you need on Thermal Paste: 放熱グリスの塗布方法

このアンサーは役に立ちましたか?

スコア 1

5 件のコメント:

Thank you Mayer, however, I have already seen that guide and performed it successfully on quite a few other PowerBooks, but they didn't have the 128MB ATI graphics that this machine does, and they only had thermal compound on their processor, not the graphics card. The heat sink on this machine does have two copper plates, one under the processor and one under the graphics card. I suspect that I will need to apply paste to both areas, but as it isn't described as such in the iFixit guide, I wanted to make very sure before I make a mess of things. I thought, when I pulled the faulty logic board from this machine (which has a short circuit), that the short may have been caused by compound being on the graphics card too. Then I saw the eBay picture of the logic board I just bought, and noticed compound on that graphics card too! Thanks again! ;o)

さんによる

I really don't remember seeing this problem before. Do you have the Apple part number on the logic board? Maybe I can help you do some research on this.

さんによる

The Apple part number is 820-1940-A.

And here is the eBay item with photo showing graphics card in the top centre and processor top right, both with paste residue on:

http://cgi.ebay.co.uk/ws/eBayISAPI.dll?V...

さんによる

I have this machine in my parts pile and saw the reason they missed it in the teardown, it's on the bottom side of the board. Mine has paste on it also. So I would replace it.

さんによる

Thanks Mayer, your help is greatly appreciated. ;o)

さんによる

コメントを追加

回答を追加する

Adam さん、ありがとうございました!
統計データ:

過去 24時間: 0

過去 7 日: 0

過去 30 日: 1

今までの合計 2,042