修理を始めるには コミュニティ ストア

iMac Intel 20" EMC 2133 和 2210 外圈更换

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての30個のガイドに反映されます。

ガイドに戻る
英語
中国語
前の手順 次の手順

手順 2を翻訳中

手順2
iMac Intel 20" EMC 2133 and 2210 Front Bezel Replacement: 手順 0、 1の画像 1

  • Place your hands at the top corners of the bezel (to the side) and lift the bezel 2-3cm from the body by working from the top. After this you can also disengage the bottom of the bezel (the memory modules will prevent the bottom of the bezel to detach first). When reassembling, start with the bottom of the bezel.

  • The top of the bezel hosts a microphone attached to the logic board. Gently lift the bezel to not damage the microphone wiring or connector by accidentally pulling the cable.

  • At this point, you can either detach the microphone cable and remove the bezel, or keep the microphone cable attached and rest the bezel on your work surface or the chassis of the Mac.

  • To fully detach the bezel: disconnect the microphone cable connector, removing tape as necessary.

  • To keep it attached, leave the microphone cable attached to the logic board, and place the bezel 'above' the chassis, with the microphone cable forming a hinge.

  • If you keep the microphone attached to the chassis, make sure you don't accidentally damage the microphone or logic board by bumping into the loose bezel.

断开麦克风线缆连接插头，如果有必要的话移走胶带。

要确保挡板正常，请确保将麦克风电缆和连接器插入相机板旁边的空白处。

-[* black] Disconnect the microphone cable connector, removing tape as necessary.
-[* icon_reminder] For the front bezel to sit properly, be sure to tuck the microphone cable and connector into the void next to the camera board.
+[* black] Place your hands at the top corners of the bezel (to the side) and lift the bezel 2-3cm from the body by working from the top. After this you can also disengage the bottom of the bezel (the memory modules will prevent the bottom of the bezel to detach first). When reassembling, start with the bottom of the bezel.
+[* icon_caution] The top of the bezel hosts a microphone attached to the logic board. Gently lift the bezel to not damage the microphone wiring or connector by accidentally pulling the cable.
+[* icon_note] At this point, you can either detach the microphone cable and remove the bezel, or keep the microphone cable attached and rest the bezel on your work surface or the chassis of the Mac.
+ [* black] ***To fully detach the bezel***: disconnect the microphone cable connector, removing tape as necessary.
+ [* black] ***To keep it attached***, leave the microphone cable attached to the logic board, and place the bezel 'above' the chassis, with the microphone cable forming a hinge.
+ [* icon_caution] If you keep the microphone attached to the chassis, make sure you don't accidentally damage the microphone or logic board by bumping into the loose bezel.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。