メインコンテンツにスキップ

iMac Intel 17" Display Replacement

注意:あなたはさきほど閲覧しているガイドの前提となるページを編集しています。あなたが行った変更は、この手順を含むガイド全体に影響を与えます。

英語
日本語

手順 5を翻訳中

手順5
iMac Intel 17" Display Replacement: 手順 0、 2の画像 1 iMac Intel 17" Display Replacement: 手順 0、 2の画像 2
  • Allow the EMI shield to hang down from the display.

  • Remove the four 8 mm with 2 mm thick head coarse-thread T10 Torx screws securing the display to the rear case.

  • These screws are recessed, so a thin screwdriver such as this is essential for removal. Bit drivers tend to be too short for this application.

  • It is strongly recommended to use a magnetized screwdriver so the screws won't fall into the iMac.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります