Skip to main content

注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。

英語
日本語

手順 1を翻訳中

Step 1
If you're installing a new rear glass panel, you'll also need to transfer the fingerprint sensor to your new rear glass panel as follows: Reheat an iOpener and apply it to the fingerprint sensor mounted to the rear glass. Push the fingerprint sensor off of its adhesive from the outside of the glass.
  • If you're installing a new rear glass panel, you'll also need to transfer the fingerprint sensor to your new rear glass panel as follows:

  • Reheat an iOpener and apply it to the fingerprint sensor mounted to the rear glass.

  • Push the fingerprint sensor off of its adhesive from the outside of the glass.

  • If the sensor is stubborn, gently slide a halberd spudger or opening pick under the plastic backing to loosen the adhesive before pushing.

  • This will make the adhesive less likely to be reusable, so try pushing with your finger first.

iOpenerを温めて、リアガラスに装着された指紋認証センサーの上に載せます。

ガラスの外側から指で指紋認証センサーを押し、圧着剤から外します。

センサーが頑丈で外れない場合は、圧着剤を緩めるために、スパッジャー(鉾型ヘラ)をプラスチックの裏打ちの下に丁寧に差し込みます。

この作業をすると圧着剤の再利用ができなくなります。そのため、なるべく指で押し出す作業を優先してください。

[* black] If you're installing a new rear glass panel, you'll also need to transfer the fingerprint sensor to your new rear glass panel as follows:
[*
black] Reheat an iOpener and apply it to the fingerprint sensor mounted to the rear glass.
[*

[*
black] Push the fingerprint sensor off of its adhesive from the outside of the glass.
[* black] If the sensor is stubborn, gently slide a halberd spudger or opening pick under the plastic backing to loosen the adhesive before pushing.
[* black] If you're installing a new rear glass panel, you'll also need to transfer the fingerprint sensor to your new rear glass panel as follows:
[*
black] Reheat an iOpener and apply it to the fingerprint sensor mounted to the rear glass.
[*

[*
black] Push the fingerprint sensor off of its adhesive from the outside of the glass.
[* black] If the sensor is stubborn, gently slide a halberd spudger or opening pick under the plastic backing to loosen the adhesive before pushing.
[* icon_note] This will make the adhesive less likely to be reusable, so try pushing with your finger first.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります