修理を始めるには コミュニティ ストア

iPad 3 4G Home Button Einheit ersetzen

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての11個のガイドに反映されます。

ガイドに戻る
英語
ドイツ語
次の手順

手順 1を翻訳中

手順1
iPad 3 4G Home Button Assembly Replacement: 手順 0、 1の画像 1

  • The home button assembly is attached to the front panel with some adhesive. The use of an iOpener to soften the adhesive is highly recommended.

  • Place the iOpener in the microwave and microwave it for thirty seconds on the highest power setting.

  • Be careful not to overheat the iOpener during the repair procedure. We recommend waiting at least three minutes before reheating the iOpener.

  • Place the iOpener over the home button on the front edge of the display.

Die Home Button Einheit ist mit etwas Kleber am Front Panel festgemacht. Die Benutzung eines iOpeners, um den Kleber weich zu machen, wird wärmstens empfohlen.

Lege den iOpener in die Mikrowelle und lasse die Mikrowelle eine Minute auf der höchsten Stufe laufen.

Achte während des Reparaturvorgangs darauf, den iOpener nicht zu überhitzen. Wir empfehlen, mindestens zwei Minuten vor einer erneuten Erhitzung des iOpeners zu warten.

Platziere den iOpener über dem Home Button auf der Vorderseite des Displays.

[* icon_note] The home button assembly is attached to the front panel with some adhesive. The use of an iOpener to soften the adhesive is highly recommended.
-[* black] Place the iOpener in the microwave and microwave it for ***one minute*** on the highest power setting.
- [* icon_caution] Be careful not to overheat the iOpener during the repair procedure. We recommend waiting at least two minutes before reheating the iOpener.
+[* black] Place the iOpener in the microwave and microwave it for ***thirty seconds*** on the highest power setting.
+ [* icon_caution] Be careful not to overheat the iOpener during the repair procedure. We recommend waiting at least three minutes before reheating the iOpener.
[* black] Place the iOpener over the home button on the front edge of the display.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。