Mac mini Mid 2011 Antenna Plate Replacement

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての27個のガイドに反映されます。

英語

オランダ語

手順 1を翻訳中

手順1

Remove the following screws securing the antenna plate to the mini:
Two 6.6 mm T8 Torx screws
Two 5.0 mm T8 Torx or 2.0 mm Hex screws (either screwdriver will work)
When putting back together:
It can be difficult to get the hard drive seated correctly such that the antenna plate fits in place correctly. If the screw holes don't line up with those on the hard drive, make sure that the two pins that are in the back of the hard drive are properly seated in the holes at the back of the case, above the housing for the second hard drive.
The antenna attaches directly to the hard drive (red markers), therefore attaching the antenna can move the hard drive around and loosen the connection of the hard drive cable to the logic board.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。