BCG800XL Grinder Jamming due to Worn Impeller

英語

日本語

手順 8を翻訳中

手順8

Gear / Burr holder Assembly Removal

Be sure the grind knob is turned to the finest setting.
It's critical that the alignment be preserved when removing the gear assembly. The small gear in the picture is an encoder. Its purpose is to track the position of the grind adjustment level so it can be displayed on the digital readout. If it gets out of alignment the display will end up reading wrong.
Use a permanent marker to make alignment marks on the three parts of the gear assembly. The marks should line up during reassembly.
There are 4 plastic tabs radially holding the big white gear assembly in place. I used both hands, placing my finger tips under each side of the big gear and pulled straight up to remove it.
If pulling straight up isn't working, try curling your fingers under just one side of the white gear, and prying upwards until that side pops free a little. Then do the other side.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。