メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての22個のガイドに反映されます。

英語
日本語

手順 5を翻訳中

手順5
Make sure the battery is disconnected before you disconnect or reconnect the cable in this step. Disconnect the display cable by prying it straight up from its socket on the logic board.
  • Make sure the battery is disconnected before you disconnect or reconnect the cable in this step.

  • Disconnect the display cable by prying it straight up from its socket on the logic board.

スパッジャーの平面側先端や指の爪先を使って、基板上ソケットからディスプレイデータケーブルをまっすぐ上に引き上げて外します。

[* black] Use the flat end of a spudger, or a fingernail, toicon_caution] Make sure the battery is disconnected before you disconnect or reconnect the cable in this step.
[* black] Disconnect
the display data cable by prying it straight up from its socket on the logic board.
[* black] Use the flat end of a spudger, or a fingernail, toicon_caution] Make sure the battery is disconnected before you disconnect or reconnect the cable in this step.
[* black] Disconnect
the display data cable by prying it straight up from its socket on the logic board.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります