メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての8個のガイドに反映されます。

英語
スペイン語

手順 18を翻訳中

手順18
Tip the logic board up to a vertical position to expose the single antenna connector on the underside, near the top edge of the board. Do not attempt to fully remove the logic board yet, as the Wi-Fi/Bluetooth antenna is still connected to the underside of the board. Do not attempt to fully remove the logic board yet, as the Wi-Fi/Bluetooth antenna is still connected to the underside of the board.
  • Tip the logic board up to a vertical position to expose the single antenna connector on the underside, near the top edge of the board.

  • Do not attempt to fully remove the logic board yet, as the Wi-Fi/Bluetooth antenna is still connected to the underside of the board.

Inclina la placa lógica hacia arriba en posición vertical para exponer el único conector de antena en la parte inferior cerca del borde superior de la placa.

No intentes aun de remover por completo la placa lógica, ya que la antena Wi-Fi/Bluetooth está todavía conectada al lado inferior de la placa.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります