Andis Master Clippers Motor/Coil Assembly Replacement

英語

日本語

手順 5を翻訳中

手順5

Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with red wire. However, in this case the red wire goes with the white wire (it all depends on how the manufacturer ships it). The white wire extends from the Attached power cord
Twist the red wire that is coming from the Coil Assembly with the white one, and the black wire with the black one.
CAUTION: Match the wires correctly, Black with Black, and Red with White. If you matched the wrong wire, it will cause the clippers to have a short circuit (electrical malfunction) when you plug the electrical cord into an outlet.
After you have twisted the wires together, use electrical tape to wrap the stripped wires. Leave some tape over the ends of the wires, and below the cutoff of the rubber around the wire as shown in the photo. Wrap the tape around the wires as tight as possible.
To complete this repair and reassembly, follow these steps in reverse, starting from the end of step 3 up to the beginning of step 1

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。