HP Envy 17-3070NR Fan Assembly Replacement

注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。

ガイドに戻る

英語

日本語

手順 3を翻訳中

手順3

HP Envy 17-3070NR Fan Assembly Replacement: 手順 0、 3の画像 1

HP Envy 17-3070NR Fan Assembly Replacement: 手順 0、 3の画像 2

HP Envy 17-3070NR Fan Assembly Replacement: 手順 0、 3の画像 3

Remove the three 4.5mm Phillips screws on the fan assembly.
Loosen the seven captive Phillips screws in the ascending numerical order (1-7). Numbers are printed next to each screw on the housing.
Screws will not fully come off the assembly. You need to only loosen them.
Remove the fan assembly from the system board by lifting it straight up.
For reassembly, you will need to clean the old thermal paste off of areas highlighted in yellow as well as matching parts on the fan assembly. Following that, you would need to reapply thermal paste before putting back the fan assembly. Small amount of the size of the rice grain should be enough for each plate.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。