修理を始めるには コミュニティ ストア

Sostituzione del filtro EMI su un display Apple Thunderbolt

ご注意：あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

ガイドに戻る
英語
イタリア語
次の手順

手順 1を翻訳中

手順1
Apple Thunderbolt Display EMI Filter Replacement: 手順 0、 2の画像 1 Apple Thunderbolt Display EMI Filter Replacement: 手順 0、 2の画像 2

  • You should now see the EMI filter right in the middle of the device (although held in by a few other components).

  • Follow the wires coming out of the bottom of the Power adapter off to the left.

  • Take the tweezers and remove the piece of tape holding the wires to the casing.

  • There is only one connector that needs to be taken out (even though there are two right next to each other!).

  • Grab the connector from the bottom and pull it carefully from its corresponding socket.

Dovresti vedere il filtro EMI al centro del dispositivo (anche se tenuto fermo da diverse componenti.)

Segui i cavi che partono da sotto l'alimentatore a sinistra.

Usa un paio di pinzette per rimuovere il pezzo di nastro adesivo che fissa i cavi alla scocca.

Solo un connettore deve essere rimosso (anche se ce ne sono 2, uno accanto all'altro!).

Prendi il connettore da sotto e tiralo attentamente fuori dalla sua presa.

[* black] You should now see the EMI filter right in the middle of the device (although held in by a few other components).
[* black] Follow the wires coming out of the bottom of the Power adapter off to the left.
-[* black] Take the tweezers and remove the piece of tape holding the wires to the casing.
+[* black] Take the [product|IF145-020|tweezers] and remove the piece of tape holding the wires to the casing.
[* black] There is only one connector that needs to be taken out (even though there are two right next to each other!).
[* black] Grab the connector from the bottom and pull it carefully from its corresponding socket.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。