iPod Nano 5th Generation Logic Board Assembly Replacement

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての3個のガイドに反映されます。

英語

韓国語

手順 5を翻訳中

手順5

Continue to push the logic board assembly through the outer case of the iPod with a spudger.
Tolerances inside the Nano are extremely tight. Be very patient and go slowly when removing the logic board assembly, and make sure no components or ribbon cables get caught on the case.
To make sure that the hold switch plate does not catch on the housing of the iPod and tear the cable, feed the switch straight down the center of the device, where the opening is the widest.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。