修理を始めるには コミュニティ ストア

Remplacement de l'ensemble carte mère de l'iPod Nano 5ème génération

注意：あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての3個のガイドに反映されます。

ガイドに戻る
英語
フランス語
次の手順

手順 1を翻訳中

手順1
iPod Nano 5th Generation Logic Board Assembly Replacement: 手順 0、 3の画像 1 iPod Nano 5th Generation Logic Board Assembly Replacement: 手順 0、 3の画像 2 iPod Nano 5th Generation Logic Board Assembly Replacement: 手順 0、 3の画像 3

  • Use a heat gun to soften the adhesive underneath the camera/microphone cover.

  • Pry the camera/microphone cover off the case with a metal spudger and remove it.

  • It is extremely difficult, if not impossible, to avoid damaging the iPod case near the camera. While this will not affect the iPod's functionality, it will hurt its cosmetic appearance.

  • You can try this alternative method for removing the cover:

  • Use a hot glue gun to apply a bead of glue across the cover.

  • Move the nozzle in the glue for 20 seconds to heat the lens adhesive holding the lens in place.

  • Press a spudger into the hot glue and hold it in place until the glue cools and hardens.

  • Pull on the spudger with firm steady force, while using a fingernail to pry on the cover edge.

Utilisez un pistolet à air chaud pour ramollir l'adhésif sous le cache de la caméra/du microphone.

Décollez le cache de la caméra/du microphone de la coque avec un spudger en métal et enlevez-le.

Il est extrêmement difficile, voire impossible, d'éviter d'endommager la coque de l'iPod près de la caméra. Bien que cela n'affecte pas les fonctionnalités de l'iPod, cela nuira à son aspect physique.

[* black] Use a heat gun to soften the adhesive underneath the camera/microphone cover.
[* black] Pry the camera/microphone cover off the case with a metal spudger and remove it.
-[* icon_note] It is extremely difficult, if not impossible, to avoid damaging the iPod case near the camera. While this will not affect the iPod's functionality, it will hurt its cosmetic appearance.
+[* icon_caution] It is extremely difficult, if not impossible, to avoid damaging the iPod case near the camera. While this will not affect the iPod's functionality, it will hurt its cosmetic appearance.
+[* icon_note] You can try this alternative method for removing the cover:
+ [* black] Use a hot glue gun to apply a bead of glue across the cover.
+ [* black] Move the nozzle in the glue for 20 seconds to heat the lens adhesive holding the lens in place.
+ [* black] Press a spudger into the hot glue and hold it in place until the glue cools and hardens.
+ [* black] Pull on the spudger with firm steady force, while using a fingernail to pry on the cover edge.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。