メインコンテンツにスキップ

iPhone 6 로직 보드 교체

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての4個のガイドに反映されます。

英語
韓国語

手順 15を翻訳中

手順15
iPhone 6 Logic Board Replacement: 手順 0、 1の画像 1
  • Remove the following screws securing the logic board to the rear case:

  • Two 1.9 mm Phillips screws

  • One 2.3 mm standoff screw

  • Standoff screws are best removed using a standoff screwdriver or bit.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

로직 보드를 후면 케이스에 고정하는 다음 나사를 풀어주세요:

1.9mm 필립스 나사 2개

2.3mm 스탠드오프 나사 1개

스탠드오프 나사는 스탠드오프 스크루드라이버 또는 비트를 사용하여 분리하는 것이 가장 좋습니다.

부득이한 경우 작은 납작머리 스크루드라이버를 사용해도 되지만, 미끄러져 주변 부품들이 손상되지 않도록 각별히 주의하세요.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります