メインコンテンツにスキップ

Reemplazo de Placa Lógica del iPhone 6

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての4個のガイドに反映されます。

英語
スペイン語

手順 15を翻訳中

手順15
iPhone 6 Logic Board Replacement: 手順 0、 1の画像 1
  • Remove the following screws securing the logic board to the rear case:

  • Two 1.9 mm Phillips screws

  • One 2.3 mm standoff screw

  • Standoff screws are best removed using a standoff screwdriver or bit.

  • In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

Quita los siguiente tornillos asegurando la placa logica a la caja trasera:

Dos tornillos Phillips de 1.9 mm

Un tornillo standoff de 2.3 mm

Los tornillos de separación se separan mejor con un destornillador de separación o similar.

Un destornillador de punta plana también puede hacer el trabajo, pero ten especial cuidado para asegurarse de que no resbale ni dañe los componentes circundantes.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります