メインコンテンツにスキップ

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての26個のガイドに反映されます。

英語
イタリア語

手順 3を翻訳中

手順3
Use a the flat end of a spudger or a fingernail to carefully pop the two digitizer cable connectors straight up from their sockets. To avoid damaging your iPad, pry only on the connectors themselves, not on the socket on the logic board. To avoid damaging your iPad, pry only on the connectors themselves, not on the socket on the logic board.
  • Use a the flat end of a spudger or a fingernail to carefully pop the two digitizer cable connectors straight up from their sockets.

  • To avoid damaging your iPad, pry only on the connectors themselves, not on the socket on the logic board.

Usa l'estremità piatta di uno spudger o un'unghia per scollegare i due connettori dedel cavo del digitizer dai rispettivi zoccoli.

Per evitare danni al tuo iPad, fai leva solo sul cavo, non sul connettore della scheda logica.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります