メインコンテンツにスキップ

Sostituzione LCD iPad Air Wi-Fi

注意:あなたは必要条件ガイドを編集しています。あなたが行なう変更は、この手順を含む全ての28個のガイドに反映されます。

英語
イタリア語

手順 3を翻訳中

手順3
iPad Air Wi-Fi LCD Replacement: 手順 0、 3の画像 1 iPad Air Wi-Fi LCD Replacement: 手順 0、 3の画像 2 iPad Air Wi-Fi LCD Replacement: 手順 0、 3の画像 3
  • Do not attempt to fully remove the LCD. It is still connected to the iPad by several cables at the home button end. Lift only from the front-facing camera end.

  • Use the flat end of a spudger to pry the LCD out of its recess just enough to grab it with your fingers.

  • Flip the iPad LCD like a page in a book, lifting near the camera and turning it over the home button end of the rear case.

  • Be gentle and keep an eye on the LCD cables as you flip the display over.

  • Lay the LCD on its face to allow access to the display cables.

  • Set the LCD down on a soft, clean, lint-free surface.

Non provare a rimuovere completamente l'LCD: è ancora connesso all'iPad da molteplici cavi alla fine del tasto home. Sollevalo solo dall'estremità anteriore della fotocamera.

Usa l'estremità piatta di uno spudger per estrarre lo schermo dal suo alloggiamento quanto basta per poterlo afferrare con le dita.

Capovolgi l'LCD dell'iPad come una pagina di un libro, sollevandolo vicino alla fotocamera e ruotandolo sull'estremità del pulsante home del case posteriore.

Sii delicato e stai attento ai cavi dello schermo quando lo capovolgi.

Disponi il display di piatto per consentire l'accesso ai suoi cavi.

Appoggia l'LCD su una superficie pulita e morbida.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります