メインコンテンツにスキップ

Learn to solder electronics with the Maker Shed Solder Badge!

英語
日本語

手順 17を翻訳中

手順17
Learn to solder electronics with the Maker Shed Solder Badge!, Position the LEDs: 手順 0、 3の画像 1 Learn to solder electronics with the Maker Shed Solder Badge!, Position the LEDs: 手順 0、 3の画像 2 Learn to solder electronics with the Maker Shed Solder Badge!, Position the LEDs: 手順 0、 3の画像 3
Position the LEDs
  • LEDs are polarized: one side of the diode is positive, the other is negative. It is typical convention for an LED to be manufactured with its positive lead longer than the negative lead.

  • Positive lead (longer)

  • Negative lead (shorter)

  • Insert the LED into the PCB as illustrated. Be sure to match up the positive lead of the LED (the longer one) with the positive pad on the PCB (marked with a "+").

  • Bend one of the leads down tightly. This serves as a securement so the part doesn't fall away while you solder.

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

ここに翻訳を挿入する

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります