ご注意：あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。
手順 12を翻訳中
手順12
-
Roll the thermal putty into a ball.
-
Place the thermal putty where the damaged thermal pad was, making sure it's centered over the component—in this case a memory chip.
-
Optionally, you can use the flat end of a spudger (or an included applicator) to spread the thermal putty over the surface of the component.
| + | [* black] Roll the thermal putty into a ball. |
|---|---|
| + | [* black] Place the thermal putty where the damaged thermal pad was, making sure it's centered over the component—in this case a memory chip. |
| + | [* black] Optionally, you can use the flat end of a spudger (or an included applicator) to spread the thermal putty over the surface of the component. |
| + | [* icon_note] When you reattach the heat sink, you'll compress the thermal putty and it'll spread the ball out. |
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。