Xbox One Elite Wireless Controller Series 2 Teardown

ガイドに戻る

英語

イタリア語

前の手順次の手順

手順 7を翻訳中

手順7

Xbox One Elite Wireless Controller Series 2 Teardown, Remove the Motherboard: 手順 0、 3の画像 1

Xbox One Elite Wireless Controller Series 2 Teardown, Remove the Motherboard: 手順 0、 3の画像 2

Xbox One Elite Wireless Controller Series 2 Teardown, Remove the Motherboard: 手順 0、 3の画像 3

Remove the Motherboard

Now, for the serious stuff—There are four solder points on the left and right that can be de-soldered depending on what is required during a repair. The temperature required to remove is approx 450 degrees C.
If you arent removing the solder be careful while removing the motherboard in this step.
Remove the 2 T6 Torx screws (yellow circle) and gently slide the motherboard up along the two dowel pins (red circle). The motherboard (green) can now be repositioned away from the daughterboard(blue).
The black and grey wires are looped through the plastic tabs on either end as well as around the front of the plastic panel (yellow circle), removing them from here can allow more free room without de-soldering.
The headphone jack can now also be removed (red square)

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。