メインコンテンツにスキップ

Apple Thunderbolt Display ist schwarz - Reparatur des Bildausfalls

英語
ドイツ語

手順 7を翻訳中

手順7
Apple Thunderbolt Display Black Blanking Out Repair, Peel Tape and Unscrew T-Con Buffer Board Cover: 手順 0、 3の画像 1 Apple Thunderbolt Display Black Blanking Out Repair, Peel Tape and Unscrew T-Con Buffer Board Cover: 手順 0、 3の画像 2 Apple Thunderbolt Display Black Blanking Out Repair, Peel Tape and Unscrew T-Con Buffer Board Cover: 手順 0、 3の画像 3
Peel Tape and Unscrew T-Con Buffer Board Cover
  • Peel off black tape surrounding the cover. Careful around the 3 connector regions (notes below) Peel off foil tape at the 2 ends of cover. Remove 4x phillips screws.

  • LCD connector is very difficult. Its a flip latch connector with a handle tape just like the other end of cable. The handle tape covered under 2 differnet sticky tapes.

  • First peel off the black tape and carefully separate the LCD connector latch handle tape.

  • Next peel off the aluminum tape and latch handle tape is finally liberated.

  • Note iMac LCD (same model as TB Display) may seal this connector area differently from Thunderbolt Display LCD.

Entferne das schwarze Klebeband um die Abdeckung herum. Sei vorsichtig an den drei Anschlussbereichen (siehe unten). Entferne das Folienband an den zwei Enden der Abdeckung. Entferne die vier Kreuzschlitzschrauben.

Der LCD-Anschluss ist sehr schwierig. Es ist ein Klappverschluss mit einem Griffband, genau wie am anderen Ende des Kabels. Das Griffband ist mit zwei klebrigen Bändern bedeckt.

Ziehe zuerst das schwarze Klebeband ab und löse vorsichtig das Griffband des LCD-Steckers. Ziehe dann das Aluminiumband ab, damit ist das Griffband frei.

Glossar für die Bilder:

foil - Folie

LCD connector - LCD-Anschluss

temp sensor cable connector under tape - Temperaturfühler-Kabelstecker unter Klebeband

Cut LCD Display Connector Locking Clip Handle Tape - Griffband des Klappverschlusses vom LCD-Anschluss abschneiden

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります