注意:あなたはさきほど閲覧していたガイドの前提条件を編集しています。あなたが行った変更は、この手順を含む個のガイド全体に影響を与えます。
手順 1を翻訳中
手順1
-
Remove six 4 mm screws using a JIS #0 screwdriver.
-
Insert the flat end of a spudger in the gap between the motherboard and the rest of the mouse.
-
Slowly pry up the edge of the board, moving around the mouse slowly in a counterclockwise direction.
クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります。