メインコンテンツにスキップ

Remplacement des bandes adhésives d'un iMac Intel 27" EMC 2546

ご注意:あなたは前提となるガイドを編集しています。あなたが行なう変更は、この手順を含むガイド全体に反映されます。

英語
フランス語

手順 13を翻訳中

手順13
iMac Intel 27" EMC 2546 Adhesive Strips Replacement: 手順 0、 2の画像 1 iMac Intel 27" EMC 2546 Adhesive Strips Replacement: 手順 0、 2の画像 2
  • Use painter's tape or masking tape to temporarily secure the bottom edge of the display to the iMac's enclosure.

  • The tape preserves the display's alignment, and allows you to safely swing the top edge of the display open to access the display cables.

Répétez les 3 étapes précédentes pour placer la bande 15 sur le côté gauche du bord inférieur de l'arrière du panneau de l'écran.

Les bandes 14 et 15 devraient venir en butée bord à bord au centre de l'écran.

-[* black] Repeat the previous 3 steps to place strip 15 on the left side of the bottom edge of the back of the display panel.
-[* black] Strips 14 and 15 should butt up against each other in the center of the display.
+[* black] Use painter's tape or masking tape to temporarily secure the bottom edge of the display to the iMac's enclosure.
+ [* icon_note] The tape preserves the display's alignment, and allows you to safely swing the top edge of the display open to access the display cables.

クリエイティブコモンズのオープンソース著作権のもと、あなたの投稿は著作権の対象となります